Filter
Top Products
E – 17
The horizontal and vertical positions of the
image can also be adjusted manually. See
page 27.
If you have set “AUTO MODE” to “OFF” to carry
out the above described adjustments (see
page 27 for details), you can choose to project
the image at the original size of the incoming
signal resolution. (Normally, the image is
enlarged or reduced to the most suitable size
automatically.) See page 27.
9 Adjust the picture elements (see page
28), then select the picture type
according to the video content (see page
28).
10
Start using the unit.
The following functions are available while using
the unit:
• Adjusting the volume of the unit's speaker
(see pages 19 and 25),
• Using the laser pointer (see page 19),
• Turning off the image and muting the sound
temporarily (see page 19),
• Freezing a moving picture (see page 19),
• Enlarging the picture (see page 20), and
• Enlarging the picture after selecting the
portion you wish to enlarge (see page 21).
Note
If “POWER OFF” is set to “ON” (see page 29), the image will
be turned off if the unit has been left unoperated for five
minutes with an RGB input source.
If the image is suddenly turned off while projecting a computer
image, the computer’s screen saver or power management
function may be activated.
VIDEO
RGB
S-VIDEO
OFF ONPOWERPOWER
After using the unit
1 Press POWER OFF on the remote control,
or POWER on the unit, for two to three
seconds.
When you have turned off the unit, the POWER
indicator will start flashing then turn to amber in
one minute.
Never disconnect the power cable while the
POWER indicator is flashing.
Notes
• Neither POWER ON on the remote control nor POWER on
the unit operate while the POWER indicator is flashing.
• Wait at least one minute before turning on the unit again.
POWER ON on the remote control or POWER on the unit
may not operate if you try to turn on the unit again within one
minute after turning off the unit.
2 After the POWER indicator stops flashing
and turns to amber, disconnect the power
cable from the wall outlet, then from the
unit.
The POWER indicator goes out.
Note
Hold the plug when disconnecting the power cable. Never pull
the cord.
(Continued on next page.)
POWER
Green light flashes
(About one minute)
↓
Then lights steadily
in amber