Polycom RAS200A Server User Manual


 
Getting Started Guide
1 - 6
Connected Via Hub
If you are using a PC connected to the RAS200A system via a hub, you must:
1. Change your computer’s network’s settings. To do this, see Configuring
the PC Network to Connect to the RAS200A on page 1-6.
2. Configure the Polycom RAS200A. See Chapter 2, ,Completing the First
Time Setup.
3. Restore your computer’s orginal network settings.
Configuring the PC Network to Connect to the RAS200A
To configure network settings on your local computer
1. Record the original IP address and subnet mask of your computer, so that
you can restore these values after you have finished system setup.
2. From the Start menu, choose Control Panel > Network Connections >
Local Area Connection Properties.
3. Select Internet Protocol (TCP/IP), and then click Properties.
4. In the Internet Protocol (TCP/IP) Properties dialog box, enter these
settings:
IP address: 192.168.1.37
Subnet mask: 255.255.255.0
Default gateway: Leave blank, or do not change.
Preferred DNS server: Leave blank, or do not change.