Filter
Top Products
3
BestLink SNMP/WEB Adapter User’s Guide : LTM-1343 B Draft 10/03/2001
CHAPTER 2
INSTALLATION
Installing the Internal BestLink Adapter
CAUTION
Before installing or removing the BestLink SNMP/WEB Adapter, the UPS MUST be turned off.
Hot-swapping is prohibited.
To install the internal BestLink SNMP/WEB Adapter, perform the following
steps:
1. Remove the BestDock cover on the UPS rear panel. Retain the
screws.
2. Install one of the mounting plates on the BestLink Adapter according
to your UPS model. Use the supplied screw to secure the mounting
plate to the adapter.
Any one of the three tabs can be removed from the three-tab
mounting plate so that the adapter fits securely into the UPS slot.
3. To prevent electrostatic discharge (ESD), place one hand on a metal
surface such as the UPS rear panel.
Slide the BestLink Adapter into the open slot and secure with the
screws removed in Step 1 (see Figure 2).