Filter
Top Products
Using the CD Color Printer III with Windows 11
Section 3: Using the CD Color
Printer III with Windows
A. CONNECTING THE PRINTER TO YOUR COMPUTER
The CD Color Printer III is designed to be used with nearly any
IBM-PC
®
or compatible running Windows NT/2000, or
Windows 95/98.
The printer is equipped with a standard 8-bit Centronics-type
parallel port. This port is the means through which it receives
data from your computer. To connect the printer to your
computer, simply obtain a shielded, bi-directional parallel
cable, and refer to the following steps:
NOTE:
For faster printing, your computers parallel port mode should be set
to ECP. If you experience problems with this setting or if your
computers parallel port is not ECP compatible, set your computers
parallel port to the standard Printer Port setting. Refer to your
computers system documentation for instructions on checking and/or
changing the parallel port mode.
1. Connect the Centronics-type parallel side of the cable to the
printer. Snap the fastening clips into place.
2. Connect the other side to the back of your computer at
LPT1, LPT2, or the PARALLEL connector.
510171Pr5.qxd 5/2/2000 3:39 PM Page 11
TOC
INDEX