Filter
Top Products
Printing Discs From Windows 25
Ink Saturation
This option controls the amount of ink applied to the disc.
When printing onto Primera's TuffCoat CD media, this option
can be left at its default setting of 50%. When printing onto
other brands of printable CD media, you may need to adjust
this control in order to optimize the ink saturation. Click on
the up and down arrows to change the ink saturation setting.
Lower numbers reduce the overall ink saturation, while higher
numbers increase it.
Inner Diameter
This value changes the size of the non-printed center. Larger
numbers cause the non-printed center to be larger and smaller
numbers make the non-printed center smaller. This number is
incremented by 0.1mm so a change of 10 for inner diameter
changes the diameter by 1mm.
Inner Diameter Non-Printed Diameter
440 1.733” (44mm) (Default)
383 1.507” (38.3mm) (TuffCoat
TM
)
150 0.591” (15mm) (Physical Center)
Centering Test Print
NOTE: Your printer comes from the factory pre-calibrated to print the image
in the center of the CD. You can use this adjustment if you need to
fine-tune this location.
If you ever wish to verify your factory-calibrated Vertical and
Horizontal calibration settings, you can run a simple
calibration procedure to assure that your images will be
centered when printed on a CD. To do this, refer to the
following steps:
1. Verify that a disc and a color ink cartridge are installed in
the Printer. It is important to use the same disc you
normally use for your printing because different brands of
discs may vary slightly in size. Also, verify that the Printer
is powered ON and that it is connected to your computer.
2. Click on the Centering Properties Test Print button. The
printer will begin printing the calibration test print.
510685.qxd 4/14/03 3:18 PM Page 25
TOC
INDEX