Filter
Top Products
77
Go To Standby
Purpose: The purpose of this command is to place the Serial
Adapter in Standby mode in order to conserve current. For this
command to work properly, the RTS line at the Serial Adapters
serial connector must be inactive. The Serial Adapter can be
removed from Standby mode by asserting the RTS line.
Response Expected from Serial Adapter = None.
Message format:
BYTE command (ASCII ‘G’, 47H)
Initialize Serial Adapter
Purpose: To initialize the Serial Adapter.
Response Expected from Serial Adapter: “Initialization Confirma-
tion”
Message Format:
BYTE command (ASCII ‘I’, 49H)
BYTE seqno
Set Radio Channel
Purpose : To set the Serial Adapter’s radio channel.
Response Expected from Serial Adapter: “Radio Channel Confir-
mation”