Filter
Top Products
20
Caution
Turn off the power of both the projector and computer before connecting to the CONTROL port.
Connect the computer to the CONTROL terminal of the projector using an appropriate cable.
Refer to the instruction manual for each device before connecting them through the CONTROL port.
Connecting to a Control Signal
1. CONTROL terminal
Pin No
.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
RS232C
GND
RDP
TDP
2. Mouse emulation
(1) Turn the projector and computer off.
(2) Connect the projector and the mouse terminal of computer using an appropriate cable.
(3) Turn on the projector.
(4) Turn on the computer.
(5) Start mouse emulation mode.
If you cannot start mouse emulation, reset the computer with a soft reset or by pressing the reset switch.
NOTE: For some Notebook computers with internal pointing devices, mouse emulation will not work
without disabling the internal pointing device. Check your Notebook PC manual for the correct
procedure to disable the internal pointing device.
D-sub 15 pin terminal (Male)
PS/2
CLK
DATA
SEL0
SEL1
GND
+5V
Mouse
ADB
SDATA
SEL0
SEL1
GND
+5V
Serial
TDM
SEL0
SEL1
READY
GND