Proxima ASA DP5800 Projector User Manual


 
Troubleshooting
Check the following before asking for service.
If trouble continues, call your dealer or Proxima Technical Support.
Phone: 619-457-5500, Worldwide Web: http://www.proxima.com
Problem
No picture or sound.
Sound is heard with
no picture.
Color is weak and tint is
incorrect.
Picture is dark.
Picture is not clear.
LAMP indicator glows
red.
TEMP indicator glows
red.
LAMP indicator blinks
red.
Possible Cause
•The Main power is not turned on.
•The power cord is disconnected.
•The setting of the input source is not
correct.
•Wiring to the projector is not correct.
•Wiring to the projector is not correct.
•The volume is set to minimum.
•The unit is set in Mute mode.
•Wiring to the projector is not correct.
•The brightness is set too dark.
The color and tint have been adjusted
incorrectly.
•The brightness and contrast have been
adjusted incorrectly.
•The lamp has not been adjusted.
Focus is not correct.
Trouble with the lamp.
Inside of the projector is too hot.
Air filter is detached.
Action
•Turn the MAIN POWER switch on.
•Insert the power cord into an AC socket.
•Set the correct input using the input
select button of the projector or the
remote control.
•Connect the cable correctly.
•Connect the cable correctly.
•Press the VOL button.
•Press the MUTE button.
•Connect the cable correctly.
•Press the MENU button, select BRIGHT
and press the
button.
Adjust the color and tint.
•Adjust the brightness and contrast.
•Replace the lamp with a new one.
Adjust the focus.
Turn off the power and let it rest for 20
minutes. Then, turn the power on again.
Check the ventilation holes.
Reseat the air filter.
Page
9
6
6, 7, 9
6, 24
6, 24
6, 7
6, 7
6, 24
12, 13
12, 13
12, 13
26
6, 7, 9
11, 26
11
11, 26
Power does not turn on.
Picture is displayed with
no sound.
27