Proxima ASA DP5800 Projector User Manual


 
7
RIGHT
STANDBY/ON
RISET
FOCUSZOOM
TIMER
BLANK
POSITION MUTE
RGB1/2VIDEO1/2
INPUT
VOL
MENU
RIGHT
RESET
Your DP5800 Projector (continued)
Remote control
How to insert batteries
1 . Remove the battery
compartment cover.
Slide the battery compartment
cover in the direction of the
arrow while pressing slightly
down on it.
2 . Insert the batteries as
illustrated inside the
battery compartment.
3 . Replace the cover.
Caution
Cautions on remote
control use
Do not drop the remote control or apply any shock to it.
Do not let the remote control get wet and do not put it on
a wet object.
If you are not going to use the remote control for a long
time, remove the batteries from it.
If operation of the remote control becomes difficult,
replace the batteries.
Caution
Cautions on use of batteries
Do not use batteries not specified for this unit. Do not use
old and new batteries together. It may cause a fire, injury
due to burst of battery or liquid leakage.
When inserting batteries, pay attention to the direction of
the
and polarity indications and insert the batteries
correctly. If the polarities are not correct, it may cause
injury or damage near the unit due to a battery explosion
or liquid leakage.
MENU STICK SWITCH
Selects or adjusts the menu items in
Menu mode.
Works as the mouse in Play mode.
RESET / RIGHT button
Resets menu items to factory settings
when menus are open.
Works as right mouse button in
Computer mode.
MENU ON / OFF button
Displays or removes the on-screen
menus.
FOCUS button
Adjusts focus.
VOLUME button
Adjusts volume.
MUTE button
Turns the Audio off.
STANDBY / ON button
Power ON/OFF button.
OFF sets the unit in Standby mode.
ZOOM button
Adjusts picture size.
TIMER ON / OFF button
Displays or removes the TIMER menu.
When a Blank screen is displayed,
TIMER can not be set. (See page 15.)
BLANK ON / OFF button
Displays a blank screen which can be
revealed by moving the MENU STICK
SWITCH. (See page 14.)
POSITION button
Move the picture with the MENU STICK
SWITCH while pressing the POSITION
button.
INPUT SELECT button
Selects the input source.