Filter
Top Products
2 - 1
II. QUICK START-UP
A. CONNECTING CABLES
1. Serial connection
All the external connectors are in the recessed area at the
rear bottom. The serial connector is a 9 pin D sub Female
connector at the right in the picture above. Apply the male
connector of RS232 cable to this port for serial application. Please
note that when serial connection is used, there must be no cable
connection at the parallel port on the printer. The default protocol
used in serial connection is 9600 bps, none parity check, 8 data
bits, 1 stop bit.
2. Parallel connection
The parallel connector is a 25 pin D sub Male connector at
the leftmost location in the connector area. Apply the female end
of the parallel cable at this port for parallel application. Please
note that when parallel connection is used, there must be no cable
connection at the serial port on the printer. Please also check the
DIP switch settings inside the service window at bottom side of
the printer following instructions later in this chapter.
3. Peripheral connection
The peripheral controller is a RJ11 jack near the serial
connector. With use of Posiflex cash drawer cable 20863018001
(CCBLA-180-1), this port can control a Posiflex cash drawer
CR3100 or CR3200 or CR4000 or CR4210. If a Posiflex special