Filter
Top Products
2 - 3
B. LOADING / REPLACING RIBBON
CASSETTE
• Turn off the power to the printer.
• Lift the front end of the top cover
to remove it.
• Open the auto cutter by pulling the
tab up if it is installed in the printer.
(PP5600B)
• Remove slack in the ribbon by
turning the ribbon feed knob of the
ribbon cartridge counterclockwise. The
ribbon must be properly tightened to be
able to set in position in installation.
Never turn the knob the other way
round or the ribbon may mess up inside
the cassette and ruin the whole
cassette.
• If in process of replacing the
ribbon cassette, the cassette shall
be removed in the manner that the
side of the knob is pulled up first
with the end of the holding tab
remain held down.
• Place the ribbon cartridge in
position as shown in the picture.
Seat the side with the holding tab
first then press down the whole
cassette. Rotate the ribbon feed
knob counterclockwise during the
action pressing down the ribbon
cartridge into position to help the
installation operation if necessary.
Pressing this end
Pull up this end to remove
Seat this end first
Ribbon feed knob
Lift
Tab
Fastening
Knob