Filter
Top Products
1–Product Overview
Multi-boot Image for 10Gb CNA—CNA Function Configuration Utility
SN0054671-00 A 1-9
Function
The Function parameter applies only to only function 0 and function 1. Press the
ENTER key to configure either PXE or iBFT settings. (The Function option is
predicated on the Protocol that is selected.)
Adapter Settings
Press the ENTER key on the Function number to access Adapter Settings, and to
configure PXE Boot or iBFT.
PXE. The following are available when Protocol is set to PXE:
Setup Menu Wait Time (0–15: the default is 5 seconds)
Specifies the time in seconds the menu will wait.
Enable PXE Boot (Enabled/Disabled: Default—Disabled)
Enter to toggle between Enabled and Disabled. Use the Enable PXE
Boot option to attempt a PXE boot on the selected function.
iBFT. The following parameters are available when Protocol is set to iBFT:
Enable ROM (Enabled/Disabled: Default—Enabled)
Enter to toggle between Enabled and Disabled. Use the Enable ROM
option to attempt iBFT boot on the selected function.
IP Format (IPv4/IPv6: Default —IPv4)
Enter to specify IPv4 or IPv6 address format.
VLAN Mode (Enabled/Disabled: Default—Disabled)
This setting enables VLAN.
VLAN ID (2 – 4095: Default—2)
Enter to specify the VLAN ID.
NOTE:
For an embedded LAN on motherboard (LOM), the Enable PXE Boot
parameter is controlled by the system BIOS and is non-configurable in
the CNA Function Configuration utility.
NOTE:
For an embedded LOM, the Enable PXE Boot parameter is controlled
by the system BIOS and is non-configurable in the CNA Function
Configuration utility.