Filter
Top Products
1–Product Overview
Multi-boot Image for 10Gb CNA—CNA Function Configuration Utility
1-10 SN0054671-00 A
Initiator Settings
Enable DHCP (Enabled/Disabled: Default—Enabled)
When Enable DHCP is set to Enabled, the adapter utilizes DHCP to obtain
its IP address, subnet mask, and gateway IP address.
Target Param From DHCP (Enabled/Disabled: Default—Enabled)
When Target Param From DHCP is set to Enabled, the adapter uses
DHCP to obtain the target IP address, subnet mask, and gateway IP
address.
Initiator Name (Programmed during manufacturing)
Enter to modify the iSCSI name of the initiator.
Initiator IP Address
When Enable DHCP is set to Disabled, this field must contain a valid IP
address.
Initiator Subnet Mask
When Enable DHCP is set to Disabled, this field must contain a valid
subnet mask.
Gateway
When Enable DHCP is set to Disabled, this field must contain a valid
gateway address.
Reverse CHAP Name
Enter to configure bidirectional CHAP name.
Reverse CHAP Secret
Enter to configure Bidirectional CHAP secret.
Primary/Secondary Target Settings
When Target Param From DHCP is set to Disabled, enter to manually
configure the target parameters.
Target Name
Enter to specify the iSCSI name of the intended boot target. (Depending on
your configuration, it may not be necessary to configure this option).
Target IP Address
This field must contain a valid IP address of the intended iSCSI boot target.
Target Port
Enter to specify the port used by the target. (By default, iSCSI uses
port 3260—do not modify this unless it is necessary.)