Filter
Top Products
SN0051408-00 C 3
4. Configure FCIP routes from the QRouter command line interface (CLI) using a Telnet session or serial
connection (see Figure 3-1) with the fciproute add command, or from iSCSI/FC Router Manager
(see Figure 3-2).
Figure 3-1. Configuring FCIP Routes from CLI
QRouter (admin) #> fciproute add
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
WARNING:
The following command might cause a loss of connections to both GE ports.
Configuring FCIP Route: 1
---------------------------
FCIP Interfaces FC & GE (0=Enable, 1=Disable) [Enabled ]
FC Port (1=FC1, 2=FC2) [FC1 ]
GE Port (1=GE1, 2=GE2) [GE1 ]
IP Address [0.0.0.0 ] 10.3.4.101
Subnet Mask [0.0.0.0 ] 255.255.255.0
Gateway IP Address [0.0.0.0 ]
Remote IP Address [0.0.0.0 ] 10.3.4.100
Jumbo Frames (0=Enabled, 1=Disabled) [Disabled ]
TCP Window Size (0=8KB, 1=16KB, 2=32KB) [32768 ]
Window Scaling (0=Enable, 1=Disable) [Disabled ]
TCP Port No. (Min=1024, Max=65535) [3225 ]
GE Link Rate (0=Auto, 1=10Mb, 2=100Mb, 3=1Gb) [Auto ]
FCIP Time Stamp (0=Enable, 1=Disable) [Enabled ]
Error Detect TimeOut (Min=1sec, Max=5sec) [1 ]
Resource Allocate TimeOut (Min=1sec, Max=5sec)[1 ]
Bandwidth, Mbit/sec (Min=1, Max=1000) [1000 ]
VLAN (0=Enable, 1=Disable) [Disabled ]
FCIP SW Compression (0=Enable, 1=Disable) [Disabled ]
All attribute values for FCIP Route 1 will now be saved.