Filter
Top Products
10
6. Enter the Symbolic Name for this router.
7. Select each iSCSI port and use the wizard to enter IP addresses for the iSCSI port, and optionally, the IP
address of an iSNS server.
NOTE: QLogic recommends that you enable Flow Control for your 10GbE interfaces (10GbE1 and 10GbE2
ports). You must also enable Flow Control on the Ethernet switch to which you are connecting the router.
Ethernet flow control is defined by IEEE 802.3x.
8. Save the changes; the default password is “config.”
9. Copy the FC WWPN (World Wide Port Names) for both FC Ports for each blade. You will need these names
to present LUNS from your Storage subsystem.
10. If you have an NTP Server, enable the NTP Server and enter the NTP Server information. This is located on
the Information tab that appears after you select the iSR6250 Router node in the System Tree view.
Table 3. FC Port WWPN Names for Router Blade 1 (left)
FC 1 WWPN
FC 2 WWPN
Table 4. FC Port WWPN Names for Router Blade 2 (right)
FC 1 WWPN
FC 2 WWPN