Filter
Top Products
Before removing a SSP-100 from its PCMCIA socket, the Enabler should be executed to
free the system resources allocated when the card was installed. For this operation the
Enabler provides on additional command line option:
R instructs the enabler to release the resources previously allocated to the
SSP-100. When the 'R' option is used, any settings specified by the 'B', and 'I'
options are ignored. The BIOS equipment list WILL NOT be cleared of the
SSP-100 upon execution of the release command.
2.2.1.1 Example 1
SSP100EN
In example 1, no command line argument is specified. The Enabler will report an error
and display the proper usage of the command.
2.2.1.2 Example 2
SSP100EN (s0,b300,i5)
In example 2, the Enabler will configure the SSP-100 in socket 0 with a base address of
300H and IRQ 5 using a configuration memory window at segment D000.
2.2.1.3 Example 3
SSP100EN (i10,b340,s1)
In example 3, the Enabler will configure the SSP-100 in socket 1 with a base address of
340H and IRQ 10 using a configuration memory window at segment D000.
SSP-100 User’s Manual 2-10