Filter
Top Products
FCD-IPM Installation and Operation Manual Chapter 4 Configuration
Quick Setup Menu 4-7
WAN Settings
Set this parameter for the WAN configuration.
Table 4-2. WAN Parameters
Parameters Possible Values Description
Link Status
Enable
Disable
Backup
Transmits and receives frames.
Does not transmit or receive frames. The link may be permanently disabled, for
example, when testing. A disabled line freezes all link operation, including
connection attempts and forwarding.
If a link is defined as backup to another, then whenever the main link operates
normally, the backup link is disabled. If the main link fails, the backup link begins
to operate and become enabled. You must make sure that the routing settings are
correct so that traffic will be forwarded to the desired destination via the backup
link. When you restore the main link connection, the backup link becomes
disabled again.
Default : Enable
Link Mode
Synchronous
Frame Relay
Asynchronous
Data bits are transmitted at a fixed rate. The sender and the receiver are
synchronized
A packet-switching protocol for connecting devices on a WAN.
Data bits are transmitted at a fixed rate. The sender and the receiver are not
synchronized.
Routing
IP, IPX, Bridge
Any combination
of these link
types.
Assigns the link forwarding type.