Filter
Top Products
30
BASIC PROGRAMMING STEPS
The following sections provide you with the basic instructions
for programming the AFX-300’s special features from a local
(extension) or remote touch-tone phone.
Notes
:
• You must correctly enter a 2-digit access code each time
you program the AFX-300. The AFX-300’s access code
is preset to 99. To change the code or reset the AFX-300
to the default code, see “Changing the Access Code” on
Page 34.
• You can only enter one program command per call from
a remote phone or from an extension on the same line.
• Do not set the AFX-300 so both its
TAD
and
FAX
jacks
are turned off at the same time. If you do, you might not
be able to turn on either one remotely. You must use a
touch-tone phone on the same line as your AFX-300 to
turn on either jack (see “Programming from an Extension
Phone” on Page 27).
• If you connected a programmable TAD to the same line
as the AFX-300, the TAD might respond to programming
commands intended for the AFX-300. If you are using an
extension phone, disconnect or turn off the TAD during
programming, then reconnect it when you finish. If you
are using a remote phone, turn off the
TAD
jack before
you program the other settings (see “Turn On/Off the
TAD Jack” on Page 37).
43-1245.fm Page 30 Wednesday, August 18, 1999 9:51 AM