Filter
Top Products
37
RESETTING THE SCANNER
If the scanner’s display locks up or does not work properly after you con-
nect power, you might have to reset the scanner.
Caution:
This procedure clears all the information you have pro-
grammed into the scanner. Before you reset the scanner, try turning it
off and on to see if it begins working properly. Use the following proce-
dure only when you are sure your scanner is not working properly.
1. Turn off the scanner.
2. While you press and hold down the
2
and
9
keys, turn on the scan-
ner.
PROBLEM POSSIBLE CAUSE REMEDY
Keypad does not
work.
The keylock function is
activated.
Press
KEYLOCK
until dis-
appears from the display to
turn off the keylock.
flashes on the dis-
play
The batteries are weak. Recharge the recharge-
able batteries, or replace
the non-rechargeable bat-
teries.
Error
appears on
the display.
Programming error. Reprogram the frequency
correctly.
In the scan mode,
the scanner locks
on frequencies that
have an unclear
transmission.
Programmed frequen-
cies are the same as
“birdie” frequencies.
Avoid programming fre-
quencies listed under “Bird-
ie Frequencies” or only
listen to them manually.
K
B
20-508.fm Page 37 Wednesday, August 4, 1999 1:50 PM