Filter
Top Products
35 Beyond the Basic
s
Using Signal Stalker
To turn on Signal Stalker, turn SQUELCH fully
clockwise, then press FUNC + once except in
WX search, band select, or program mode.
appears. Every 2 seconds, the scanner searches
for frequencies in the range you specified in “Setting
the Signal Stalker Options” on Page 32.
Note: To continue scanning normally while Signal
Stalker is working, simply press SCAN.
When the scanner finds a frequency, it sounds the
alert you specified in “Setting the Signal Stalker
Options” on Page 32, and Found flashes. Press any
key to confirm the displayed frequency. Press SCAN
to resume scanning. Or press or while the
frequency and appear to select the band where
you are searching.
To turn on Signal Stalker and turn off normal
scanning, press FUNC + twice. and - - - - - -
flash.
To turn off Signal Stalker and turn on normal
scanning, press FUNC + three times.
disappears.
F