Filter
Top Products
Special Features
39
2. Insert a pointed object, such
as a straightened paper clip,
into the reset opening on the
side of the scanner. Then
gently press the reset button
inside the opening.
±
+0+6+#.+<+0)"6*'"5%#00'4"
#
1. Turn off the scanner, then turn
it on again.
2. Hold down
TUNE/CLEAR
.
3. While holding down
TUNE/
CLEAR
, insert a pointed object
(such as a straightened paper
clip) into the reset opening on
the side of the scanner, then
gently press the reset button
inside the opening. The
display should turn off.
4. When the display turns on
again, release
TUNE/CLEAR
.
±
9KTGF"2TQITCOOKPI
You can transfer programming
data to your scanner using your
home computer and an optional
scanner PC programming kit (Cat.
No. 20-048, available at your local
RadioShack store). The
programming kit includes a CD-
ROM with the software you need
and a connecting cable.
±
1. Make sure your scanner is
turned off.
2. Follow the steps provided with
the programming kit to
connect the cable to your
computer and load the
software into your computer,
±
"016'"
±
"
Resetting the
Scanner
If the scanner still does
not work properly, you
might need to initialize
the scanner (see
“Initializing the
Scanner”).
Initializing the
Scanner
You must release the
reset button before
releasing
TUNE/
CLEAR
; otherwise
the memory might not
clear.
Wired
Programming
• If the scanner
receives no data
from the PC for
more than 20
seconds or if you
press any key,
wired program-
ming stops.
• Wired program-
ming stops if the
scanner receives
an empty channel
number.
#
"+/2146#06"
#
This procedure
clears all information
you stored in the
scanner's memory.
Initialize the scanner
only when you are
sure the scanner is
not working properly.
20-315.fm Page 39 Wednesday, July 24, 2002 2:27 PM