Filter
Top Products
Configuring Fibre Channel on your PDR Series
16 April, 2003 Fibre Channel Switch 13
To configure your Profile system for use in a Fibre Channel environment, follow the
instructions in the Profile User Manual. In addition to these instructions, you must
also set Fibre Channel Switch Mode ON. You can do this in one of two ways:
• Type the following command from the Command Prompt: fcconfig -s on.
OR
• In Configuration Manager, select Switch Compatibility Mode in the Fibre Channel
Configuration dialog box.
NOTE: You do not need to set the Fibre Channel hardware address of Profile
systems connected to the Fibre Channel switch. These addresses are assigned
dynamically in a fabric environment.