Filter
Top Products
Chapter 8
Scenario 2: Business user with TOS marking.
E-NIT-CTC-20041213-0013 v0.5
113
Queues As seen in the introduction we will need an overflow of packets in the real time
queue to a lower priority queue (WFQ4)when the EF traffic is exceeding 50% of the
bandwidth.
To do so proceed as followed:
1 Go to the IP QoS page and select the Queues tab
Expert mode -> IP Router -> IP QoS
You will now see a list of all queues per PVC.
Since we are using PVC atm_pvc_0_35 to connect to the internet we will have to
enable Propagation for the highest queue of this PVC.
2 Check the Propagate checkbox next to queue 5 of atm_pvc_0_35.
3 Click Save All to make the changes permanent.
4 The last thing that we need to do is bring down the ATM interface in order for
the new parameters to become active. This can be done in two way’s:
By switching the modem off and on again.
By opening the Speedtouch menu on the GUI and selecting RESTART
This will restart the modem without losing the configuration.