Filter
Top Products
Chapter 6
Meters, queues and IPQoS
E-NIT-CTC-20041213-0013 v0.5
81
6.6 IPQoS Command group
Introduction The IPQoS command group is used to configure the common parameters for a set of
queues instantiaded per interface.
ipqos config command The following parameters can be configured in the IPQoS command group:
Parameter Description
dest The name of the interface of which you want to configure
IPQoS. Typically, a phonebook entry.
state Enable, disable IPQoS for the interface.
discard The packet discard strategy in case of congestion.
priority The subqueue priority algorithm.
realtimerate The percentage of the bandwith.
burstsize Burst size in kilo bytes (KB).
weight1 The weight of queue 1 used for weighted fair queueing (WFQ)
or weighted round robin (WRR).
weight2 The weight of queue 2 used for weighted fair queueing (WFQ)
or weighted round robin (WRR).
weight3 The weight of queue 3 used for weighted fair queueing (WFQ)
or weighted round robin (WRR).
weight4 The weight of queue 4 used for weighted fair queueing (WFQ)
or weighted round robin (WRR).
maxpackets The maximum number of packets in all queues.
maxbytes The maximum size in kilo bytes (KB) in all queues.