Filter
Top Products
32185/32186/32192/32195/32196 Group
Starter Kit User’s Manual M3A-2154G52B
REJ10B0223-0140/Rev.1.40 Jan. 2007 Page 53 of 79
3. Reference Data
3.1 Jumper and Test Pin Lists
3.1.1 Jumpers
Table 3.1 Jumper List
Jumper No. Default Description
J1 Shorted between 1–4 Outputs a clock from X1 (surface mount-type oscillator module)
J2 Shorted between 1–2 Sets MOD1 to 0
J3 Shorted between 1–2 Power supply from VCCE
J4 Shorted between 1–2 Power supply from VCCE
J5 Shorted between 1–2 Power supply from VCCE
J6 Shorted between 1–2 Power supply from AVCC0
J7 Shorted between 1–2 Power supply from VCCE
J8 Shorted between 1–2
MOD0 is controled by EXTMOD0 or is set to 0 unless it is controled
by EXTMOD0
J9 Shorted between 1–2 Uses the CAN0 terminating resistor mounted on-board
J10 Shorted between 1–2 Enables reprogramming the mounted M32R/ECU’s internal flash
J11 Shorted between 1–2 Uses the CAN1 terminating resistor mounted on-board
J12 Shorted between 1–2 Uses the VR control (VOL0)
J13 Shorted between 1–2 Uses the VR control (VOL1)
J14 Shorted between 1–2 Connects P221/CRX0/HREQ to the extension connector (CON1)
J15 Shorted between 1–2 Connects P83/RXD0/TO25 to the extension connector (CON2)
J16 Shorted between 1–2 Connects P137/TIN23/CTX1 to the extension connector (CON1)
J17 Shorted between 1–2 Connects P136/TIN22/CRX1 to the extension connector (CON2)
J18 Shorted between 1–2 Connects P86/RXD1/TO22 to the extension connector (CON2)
J19 Shorted between 1–2 Connects P175/RXD2/TO27 to the extension connector (CON2)
J20 Shorted between 1–2
Connects P75/RTDRXD/RXD3/NBDD1 to the extension connector
(CON1)
3.1.2 Test Pins
Table 3.2 List of Test Pins
Test Pin No. Signal Name Test Pin No. Signal Name
TX1 VCC-BUS TX10 CANL1
TX 2 VCCE TX 11 CANH2
TX 3 GND TX 12 CTX1
TX 4 GND TX 13 CRX1
TX 5 RESET TX 14 FP
TX 6 MOD0 TX 15 CANL2
TX 7 CANH1 TX 16 TXD1
TX 8 CTX0 TX17 P87
TX 9 CRX0 TX 18 VREF0