Filter
Top Products
( 21 / 52 )
2.4 Connecting the Emulator System
How to connect the emulator system is shown in Figure 2.5 below.
Figure 2.5 Connecting the emulator system
(1) Connecting the Serial Interface Cable
Connect the serial interface cable (included) to the serial interface connector (J2) and the serial port
of the host machine (see Figure 2.5).
(2) Connecting the Power Cable
Connect the power supply for the emulator to the power connector (J1). The specifications of the
power supply for the emulator are listed in Table 2.6.
Table 2.6 Specification of power supply of emulator
Figures 2.6 and 2.7 show the specifications of the power connector and the applicable plug,
respectively.
Figure 2.6 Specification of power connector Figure 2.7 Specification of applicable plug
CAUTION
Note on Connecting the Power Supply of Emulator:
• Be careful about the polarity of the power supply. Connecting to the wrong electrode
could destroy internal circuits.
• The power cable included in this product package is colored red (+) and black (-).
•Do not apply a voltage other than the specified voltage of the product (4.5 to 7.0 V),
because it may cause burn injuries and the failure of internal circuits.
Connect the serial interface
cable to J2 connector
to host machine
to power supply for emulator
Connect the power cable
to J1 connector
DC 4.5 to 7.0 V, 1 APower supply voltage