Filter
Top Products
M306V8T-EPB User’s Manual 4. Hardware Specifications
REJ10J0777-0100 Rev.1.00 2005.08.01 Page 77 of 90
4.6 Notes on Using This Product
Notes on using this product are listed below. When debugging the MCU using he emulator, be careful about the following
precautions.
IMPORTANT
Note on the Version of the Emulator Debugger:
Be sure to use this product with one of the following emulator debuggers.
1. Renesas Debugger Package for M16C R8C PC7501 V.1.00.00 Release 01 or later
2. M3T-PD30F V.2.20 Release 1 or later
Note on Selecting the MCU File:
Select the MCU file “M16C6V8.mcu” at emulator startup.
Notes on Downloading Firmware:
Before using this product for the first time, it is necessary to download the dedicated firmware. Please note that,
to do this, it is necessary to start up the emulator main unit in maintenance mode. For downloading firmware,
see "2.7 Downloading Firmware" (page 27). Once the firmware has been downloaded, the product can be used
by simply turning on the power.
Do not shut off the power while downloading the firmware. If this happens, the product will not start up
properly. If the power is shut off unexpectedly, redownload the firmware.
Download the firmware with the user system not connected.
Notes on Self-check:
If the self-check does not result normally (excluding user system errors), the emulation probe may be damaged.
Then contact your local distributor.
Run the self-check with the user system not connected.
Note on Quitting the Emulator Debugger:
To restart the emulator debugger, always shut power to the emulator module off once and then on again.
Note on Display of MCU Status:
"MCU status" you can refer to in the MCU tab of the MCU Setting dialog box of the emulator debugger shows
pin levels of the user system. Make sure that proper pin levels are specified according to the mode you use.
(1) When single-chip mode is used:
CNVss: Low
(2) When memory expansion mode 16-bit data bus width is used:
CNVss: Low, BYTE: Low, HOLD*: High, RDY*: High
(3) When microprocessor mode 16-bit data bus width is used:
CNVss: High, BYTE: Low, HOLD*: High, RDY*: High