Filter
Top Products
( 22 / 42 )
Figure 3.2 USB interface connection procedure
*1 For installation, refer to "Installing the USB Device Driver" of the PD32RM user's
manual (online help).
*2 When the emulator debugger is started up for the first time or when the emulator
debugger has been upgraded, the dialog which prompts for downloading the
firmware will appear. Then, download the firmware following the messages.
Connect the included USB interface cable to the USB interface connector
of the M32100T-EZ-E.
Connect the included USB interface cable to the USB port of the host
machine.
Install the USB device driver*
1
.
Start up the emulator debugger*
2
.
Chapter 3. Setup
Figure 3.1 shows how to setup the M32100T-EZ-E.
Install the emulator debugger before setting up the M32100T-EZ-E. For installing the emulator
debugger, refer to the PD32RM release notes.
Figure 3.1 Setup procedure
3.1 Connecting the Host Machine
The emulator is connected to the host machine via the USB interface. Figure 3.2 shows how to connect
the USB interface.
Connect the host machine.
Connect the target board.
* By connecting the USB interface cable, power is supplied to the M32100T-EZ-E.