Filter
Top Products
Before Using the SH7670 CPU Board
1.5 Items to Be Prepared by User
Rev. 1.01 May 7, 2008
1-5
REJ11J0015-0101
1
1.5 Items to Be Prepared by User
The following lists the items that need to be prepared by users separately from this product.
<For SH7670 CPU board>
You need to prepare the following power supply separately from the product package in order to supply power to the
SH7670 CPU board.
Table 1.5.1 Items to Be Prepared by User (For SH7670 CPU board)
No. Item to Be Prepared by User Remark
1
5 V DC output stabilizing power supply
1.5 A
or more
<For the Development Environment>
The installation described here uses the tools made by Renesas.
To use this product following the installation, you need to prepare some items separately from the product package.
The table below lists the tools made by Renesas that users should prepare.
Table 1.5.2 Items to Be Prepared by User (Renesas Tools)
No. Item to Be Prepared by User
Product Type Name
Applicable Version
2
E10A-USB emulator for the SuperH family
HS0005KCU02H or
HS0005KCU01H
One that supports the
SH-2A
3
SuperH RISC engine C/C++ compiler package
R0C40700XSW09R Ver.9.00 release01 or more
4
Integrated development environment tool,
HEW (High-performance Embedded Workshop)
- Ver.4.03.00 or more
Notes:
• If you already have the E10A-USB emulator main unit and are using any device group other than the SH-2A group,
you need to purchase an “additional device group license tool” separately from the product package.
• For details on how to set up a new device group in the E10A-USB emulator, refer to Section 3.2.2, “Setting Up the
E10A-USB Emulator” in Chapter 3 of this manual.
1.5.1 Recommended Host Computer Environment
To use the above Renesas tools, we recommend using the host computer and the OS version listed in
Table 1.5.3
below.
Table 1.5.3 Operating Environment for the Renesas Development Tools
Host Computer
Specification
IBM PC/AT Series and Compatibles
CPU
IBM PC and its compatible incorporating Pentium III or later (600 MHz or greater
recommended) and USB 1.1/2.0 (Full Speed)
Memory
128 MB or more (at least twice the load module size recommended)
Hard disk capacity
Installation requires 100 MB or more of hard disk capacity.
(With the swap area taken into consideration, at least twice the memory size must be
available (four times or more recommended).)
OS Windows 2000, WindowsXP