Filter
Top Products
Default: [Off]
• Off
• On
Toner Saving
Sets the machine to print using a reduced amount of toner (for prints made by the copier function
only).
Default: [Off]
• Off
• On
Toner End Option
This setting is used to monitor the toner level.
Default: [Stop Printing]
• Stop Printing
Monitoring the toner level is enabled. The remaining toner level can be checked in the control
panel and on the Web Image Monitor.
• Continue Printing
The machine no longer monitors the toner level. Even when the toner runs out, printing will
continue and no messages will be displayed.
Supplies Status
• Print Cart.
Displays information about consumables. This information is displayed only if [Toner End
Option] has been set to [Stop Printing].
If [Toner End Option] is set to [Continue Printing], "**" is displayed instead of the indicator
above.
Printer Registration
Adjusts the position of the input tray. Adjust the value by using the [
] or [ ] key.
To check the registration, print a test page.
Default: [0]
• Horiz: Tray 1 (-6 to +6 mm, in 1 mm increments)
• Vert: Tray 1 (-6 to +6 mm, in 1 mm increments)
• Horiz: Bypass Tray (-6 to +6 mm, in 1 mm increments)
• Vert: Bypass Tray (-6 to +6 mm, in 1 mm increments)
Low Humidity Mode
When the machine is used in a low humidity environment, black stripes with a few millimeters width
may appear. Selecting [On] should prevent such black stripes from appearing.
7. Configuring the Machine Using the Control Panel
146