Filter
Top Products
28
2 Basic Operation
Printing at the Desired Location
This sets the location where printing starts.
Normally the origin point is set at the lower-right point of the printing area.
When [SHEET TYPE] is set to [OPAQUE], the width of
the printing area is set automatically (see "4-3 Printing
Area").
To determine the desired printing area, follow the steps in
"Setting the printing area in the left-right direction (the
direction of carriage movement)" to set the width of the
printing area. When [SHEET TYPE] is set to [CLEAR],
the printing area is not set automatically, so set the
printing area in the same way. If this setting is not made,
the printing area uses the maximum value for the FJ-52/
42.
Canceling setup cancels the printing area.
Specifying a location in the lengthwise direction
Use the [ ] and [ ] keys to move the material to the
location where you want to start printing.
In the figure, the next printing operation starts from the
location shown.
* For roll material, when the material has been returned
toward the back of the unit with the [
] key, manually
roll the material back onto the roll so that all of the
material at the back of the unit is stretched taut.
The next printing operation starts here.
Front edge of the material
Reflective tape
Knife guide
Print-start line
Original printing
area
New printing
area
Left-hand edge of the printing area Right-hand edge of the printing area
Setting the printing area in the left-right direction (the direction of carriage movement)
Printing area
Origin
* Returning the
start point in
the left-right
direction to its
original
location
Starting location in the left-right direction
Specifying a location in the left-right direction (the
direction of carriage movement)
Margin (value set for [PAGE MARGIN])
To change the start point for printing, use the [BASE
POINT] key. At this time, the printing area does not
change.
Follow the step in both "Specifying a location in the
lengthwise direction" and "Specifying a location in the
left-right direction (the direction of carriage movement)"
to set the start point.
Starting location in the
lengthwise direction
Specifying a location in
the lengthwise direction