Filter
Top Products
34
2 Basic Operation
When sending a material-cutting command from the computer to separate
the material automatically
* When the material-cutting command has not been set to "enabled" at the computer, automatic separation of
the material is not performed, even when the following setting is made.
Press the [MENU] key and [ ] key to make the
following screen appear on the display.
1
MENU
AUTO SHEET CUT
Press the [ ] key to make the following screen
appear on the display.
2
AUTO SHEET CUT
ENABLE ENABLE
Use the [ ] key to select [DISABLE], then press the
[ENTER] key.
3
AUTO SHEET CUT
ENABLE DISABLE
The material-separating location during
continuous printing
Start of the next printing operation
End of printing
Margin (value set for [PAGE MARGIN])
Location where separated
10 mm
(3/8 in.)
10 mm (3/8 in.)
2-8 When Not in Use...
When not in use, move the sheet loading lever toward the
back of the unit to leave the pinch rollers in the raised state.
The pinch rollers may be deformed if allowed to remain in
the lowered state.
NOTICE
Sheet loading lever