Filter
Top Products
Vista KVM-Series Installation and Operations Manual
21
Video fuzzy
• Cable too long or wrong type. Use coax cable for high resolution.
Mouse does not move
• The Vista is turned off after or not connected when CPU was booted
or the application using the mouse was run. Exit and re-enter
application or operating system using mouse or issue reset command.
• PS/2 mouse was not connected when the Vista was powered up or
the mouse was disconnected and reconnected. Issue the reset
command.
• Mouse translation set incorrectly.
Video not synchronized or wrong color
• The cable may be loose, reseat cable.
• Wrong CPU cable used. If you have a 9515, 9517, 9518, XGA mono
or similar monitor you must use special cables or adapters.
• Cable is defective; try using cable from another CPU if problem goes
away cable is defective.
• Port on the Vista is defective; try using another port on the Vista. If
problem goes away port is defective.
Cannot remember the configuration or access password.
• Call Rose Electronics Technical Support for instructions.