Filter
Top Products
18
Vista L-Series Installation and Operations Manual
Keep command
Press and release the left <Ctrl> key, then type “K”. The Keep command
saves all settings.
Mode command
The Vista switch supports keyboard modes 1, 2 and 3 and mouse modes
7,8, and 9. To issue the “Mode” command, press and release the left
<Ctrl> key, type “M”, then enter the mode number (1,2,3,7,8,9) followed by
<Enter>.
Mode 1 - CPU Keyboard = PC Mode 1 (Some IBM’s & PS/1’s)
Mode 2 - CPU Keyboard = PC Mode 2 (Most PCs)
Mode 3 - CPU Keyboard = Most (RISC) Unix Workstations & Rose
Translator
Mode 7 - CPU Mouse = 2 Button Serial (Microsoft) (7 Bt)
Mode 8 - CPU Mouse = 2 Button Serial (Not Used) (8 Bt)
Mode 9 - CPU Mouse = 3 Button Serial (Mouse Systems)
Maximum computers
Press and release the left <Ctrl> key, type “P”, enter the total number of
computers, and press <Enter>. This command limits the number of
computers to scan. For example on an eight-port unit, if no computers
were connected to ports 7 and 8, setting maximum computers to 6 would
bypass scanning computers 7 and 8.
Typematic command
Initial factory setting = 43. Rate = 10.9 chars/sec, Delay = 500 millisec.
See Attachment F for typematic value calculations.
Mouse type
To issue the “Mouse type” command press and release the left <Ctrl> key,
type “Q”, enter mouse type (0,1,2), and press <Enter>.
Mouse type 0 = PS/2 mouse
Mouse type 1 = Serial mouse
Mouse type 2 = Wheel mouse