RuggedCom RS969 Switch User Manual


 
2
2008 RuggedCom Inc. All rights reserved Rev104
Federal Communications Commission Radio Frequency
Interference Statement
This equipment has been tested and found to comply with the limits for a Class A digital device
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference on his own expense.
Warning:
Changes or modifications not expressly approved by RuggedCom Inc. could void the user’s
authority to operate the equipment.
Caution:
This product contains a laser system and is classified as a “CLASS 1 LASER PRODUCT”.
Caution – Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure. This product contains no user serviceable
parts. Attempted service by unauthorized personnel shall render all warranties null and void.
Should this device require service see the “Warranty and Service” section of this installation guide.
Important:
The RS969 family of products should be installed in a restricted access location where access
can only be gained by service personnel or users who have been instructed about the reasons for
the restrictions applied to the location and about any precautions that shall be taken; and access is
through the use of a tool or lock and key, or other means of security, and is controlled by the
authority responsible for the location.
Trademarks:
Ethernet is a trademark of Xerox Corporation
RuggedSwitch, RuggedRated, ROS and eRSTP are trademarks of RuggedCom® Inc.