Filter
Top Products
42
Runco CL-810 Owner’s Operating Manual
On-Screen Display Menus
The Remote Control menu shows you the primary and
secondary infrared (IR) codes assigned to the CL-810. The
Primary IR code is permanently set to +20. The secondary
IR code is also +20.
You can change the secondary IR code if either:
• Another device in the theater (a DVD player, for example) is responding to commands
from the CL-810 remote control in ways that are unpredictable or undesirable.
• You have multiple CL-810 projectors and want to control them independently, as
opposed to broadcasting commands from a single remote to all of them. In this
scenario, you can use multiple remotes programmed to use different IR codes.
Or, you can use a single remote and change the IR code as needed to address a
specific projector.
When you change the secondary IR code, the remote sends that code instead of the
primary IR code.
NOTE: The Remote Control menu is read-only and need not be visible in order to change
the secondary IR code.
To simultaneously change the secondary IR code and
synchronize that remote with a projector, point the remote at
the projector, then press and hold ◄ and ► simultaneously
for five seconds. The Remote Control edit window, shown
at right, appears. Type a new, two-digit code.
The procedure for changing the secondary IR code on the remote only is the same,
except that you point the remote away from the projector.
When you replace the projector lamp, you should also reset
the lamp timer. To do this, select Reset Lamp Timer from
the Set Up menu. Press the right-arrow key on the remote
to highlight “Yes,” then press Enter to confirm the reset.
NOTE: Reset the Lamp Timer ONLY after you replace
the lamp. Otherwise, the reported “Lamp Hours” will be
inaccurate.
WARNING! Do not exceed the recommended lamp life of 2000 hours.
An old lamp
becomes increasingly fragile and prone to sudden failure.
Reset Lamp Timer
Reset only if you
replace lamp
Are you sure?
No Yes
Remote Control ➤
Reset Lamp Timer ➤
Primary +20
Secondary
+20
Remote Control
Secondary +20