Filter
Top Products
Controls and Functions
Runco VX-4000d/VX-5000d Owner’s Operating Manual 7
PRE
L
IMINAR
Y
1. VERTICAL LENS SHIFT
Using a 3/16” hex wrench, turn this to move the lens up or down.
2. POWER LED
Lights red to indicate that the projector is in standby; lights blue to indicate normal
operation.
3. TEMP LED
Lights red to indicate that the projector has overheated and shut down.
4. INTAKE VENTS
Cool air enters the projector through these vents. To prevent overheating, ensure that
these vents are never blocked.
5. LAMP LED
Lights blue to indicate normal lamp operation; off when the lamp has failed or the
projector is off.
6. EXHAUST VENTS
Hot air exits the projector through these vents. This air can be quite hot. Ensure that
there are no heat-sensitive objects near it and that it is never blocked.
7. RUNCO LOGO / LENS CONTROL INFRARED (IR) RECEIVER
During initial installation, rotate the logo plate one quarter-turn (90 degrees) to uncover
the lens control IR receiver. This enables you to use the motorized focus and zoom
(image
size) controls.
When you have finished adjusting the zoom and focus, you can rotate the logo to
match the projector orientation: inverted (ceiling-mounted) or upright. To rotate the
logo, grip it at the sides, pull it away from the projector and turn it.
8. LENS
9. LENS COVER SCREW
Loosen this screw to remove the front jewelry, should you ever need to replace the
lens.
10. CABLE OPENING
Pass cables through this opening.
11. HORIZONTAL LENS SHIFT
Using a 3/16” hex wrench, turn this to move the lens left or right.
12. LAMP COVER
Remove this cover to access the lamp compartment.