Filter
Top Products
62 _Maintenance
3. Grasp the handles on the toner cartridge and pull to remove the
cartridge from the machine.
4. Press the green release handle to release the paper transfer belt.
Holding the handle on the paper transfer belt, lift it out of the machine.
5. With a dry lint-free cloth, wipe away any dust and spilled toner from the
toner cartridges area and their cavities.
6. Locate the long strip of glass (LSU) inside the cartridge compartment,
and gently swab the glass to see if dirt turns the white cotten black.
7. Reinstall all the compartments into the machine, and close the front
cover.
8. Plug in the power cord and turn the machine on
Cleaning the scan unit
Keeping the scan unit clean helps ensure the best possible copies. We
suggest that you clean the scan unit at the start of each day and during the
day, as needed.
1. Slightly dampen a soft lint-free cloth or paper towel with water.
2. Open the scanner lid.
3. Wipe the surface of the scanner glass and DADF (or ADF) glass until it
is clean and dry.
4. Wipe the underside of the scanner lid and white sheet until it is clean
and dry.
5. Close the scanner lid.
When you open the front cover, be careful not to touch the
underneath of the control panel (the lower part of the fuser unit). The
temperature of the fuser unit might be high and could damage your
skin.
When you open the front cover and work inside the machine, it is
highly recommend that you remove the paper transfer belt first.
Because the work you do could contaminate the paper transfer belt.
If toner gets on your clothing, wipe it off with a dry cloth and wash
it in cold water. Hot water sets toner into fabric.
If the front cover is not completely closed, the machine will not
operate.