Filter
Top Products
SAMSUNG DVM-Pro User Guide
12
Explain
This interface is possible to create and manage piping/control line.
• Draw piping manually
When connect pipe using refnet joint,
Piping/control line
04
Cad mode interface
• Draw piping automatically
After Select the main pipe which drawn
and
select
the
indoor
which
will
connect,
and
select
the
indoor
which
will
connect,
than enter, indoor will automatically
connect to main pipe.
• Draw pit
Select and check the deployment method
of outdoor pit in ‘draw pit’window. And
click the insertion point, and then copy
to each floor.
• Draw drain pipe manually
• Draw drain pipe automatically
After draw the main pipe, select the
indoor which will connect and click enter
key. Then indoor will connect the main
pipe.
• Insert the each pipe accessories on pipe.
If pipe accessories(refnet joint, Tee joint)
connected
the
pipe,
pipe
automatically
disconnect
where
the
accessories
enters
.
SAMSUNG
connected
the
pipe,
pipe
automatically
disconnect
where
the
accessories
enters
.
If you delete the pipe accessories which
connect the pipe, pipe connect again.
• Draw vertical dewatering outlets
Select and check the deployment method
of outdoor pit in ‘ draw vertical
dewatering outlets’window. And click the
insertion point, and then copy to each
floor.