Filter
Top Products
70
Connecting and Using a Source Device
2
2 Connecting and Using a Source Device
2.5 Connecting the PC module (sold separately)
2.5.1 MagicInfo
To use MagicInfo, a PC module must be connected to the product.
For details on how to connect a PC module, refer to the PC module user manual.
To change the MagicInfo settings, run "MagicinfoSetupWizard" on the desktop.
For details on how to use MagicInfo, refer to the DVD provided with the PC module.
The information in this section is subject to change without notice for quality improvement.
If a problem occurs after the operating system provided with the PC module is replaced with an
older version, or another operating system is installed, or software that is not compatible with the
provided operating system is installed, users will not be able to benefit from technical support.
They may be charged a fee for visits from service technicians. Product exchanges or refunds will
also not be available.
Entering MagicInfo mode
1 After installing and connecting the PC module to the product, turn on power for the product.
2 Press SOURCE on the remote control, and select Plug In Module.
3 Select the default application you want to run when MagicInfo starts.
MagicInfo Setup Wizard - v.1.12
Select Application - step 1
MagicInfo Pro (LAN, WAN based version)
MagicInfo-i Premium (Web-based version)
Select Later
< Back(B) Next(N) > Finish Cancel
-