Filter
Top Products
English - 11
Installing the Display on the Wall Attachment Panel (continued)
1 Remove the 4 screws on the back of the product.
3 Tighten the 4 screws in step 2 (plastic hanger
+ screw ) to the rear holes of the product.
2 Insert the screw into the plastic hanger.
(See the figure below)
☛
◆ Mount the product on the wall bracket
and make sure it is properly fixed to
the left and right plastic hangers.
◆ Be careful when installing the product
on the bracket as fingers can be
caught in the holes.
◆ Make sure the wall bracket is securely
fixed to the wall, or the product may not
stay in place after installation.
4
Remove safety pin (#) and insert the 4 product
holders into the corresponding bracket holes (
!). Then
place the product (
@) so that it is firmly fixed to the
bracket. Make sure to reinsert and tighten the safety
pin (
#) to securely hold the product to the bracket.
Wall Bracket Angle Adjustment
➢
Adjust the bracket angle to -
2
o
before installing it on the wall.
◆ The shape of the product may vary depending on the model. (The assemblies of the plastic hanger
and the screw are the same)
PDP Monitor
Wall Bracket
Wall
1 Fix the product to the wall bracket.
2 Hold the product at the top in the center and pull it
forward (direction of the arrow) to adjust the angle.
(See the figure to the right)
3 You can adjust the bracket angle between -2° and 15°.
Make sure to use the top center,
and not the left or the right side of
the product to adjust the angle.
To mount the product on the wall bracket
t.
BN68-00848F-00Eng_0803 8/3/05 9:50 AM Page 11