Filter
Top Products
Chapter 2
Setting up Your Printer
2-18
Setting up Your Printer
2-19
Installing the Printer Software
If you do not have a CD-ROM drive, you
can copy the Setup program onto floppy
diskettes.
For more information see ‘Making
Installation Diskettes’ page 2-26.
Continued
Hardware Requirements
To install and run the Printer Software you must have the following
hardware configuration:
●
120MB of available Hard disk space
●
Pentium 133 or better
●
32MB of RAM or more
Software Requirements
To install and run the Printer Software you must have the following
software configuration.
●
Windows 95 OSR2
●
Windows 98 or Windows 98 SE
●
If you are installing the software onto a Windows NT 4 Workstation,
you must have installed Service Pack 3 or higher
●
Internet Explorer 4.01 or later
1
Make sure the printer is plugged in and connected to your
computer.
2
Start Windows.
3
When the New Hardware Found message appears, click
the Cancel button.
5
Select the printer model which is connected to
your computer.
6
Select the language you want to use .
4
Insert the Setup CD-ROM into the CD-ROM drive.
The Model Selection window should appear
automatically.
If the installation does not start automatically, do
the following:
a) Click Start ➝ Run from the Windows task bar.
b) Type e:\Setup.exe (substitute your CD-ROM drive
letter for the ‘e’) on the command line, then click the
OK button.
Installing the printer software
1
1
02-M30UK(2-12 to 2-21) 5/22/00 3:41 PM Page 18