Filter
Top Products
14
3. MagicLAN Installation For
Windows 98/ME/NT4.0/2000/XP
We will explain the installation method for SWL-2210M/P (MiniPCI/PCI Card)
.
3.1 Installation Overview
Here are some steps you will perform in establishing your wireless network connection:
1. Install the Access Point at first. AP is needed in case of Infrastructure network
mode.
2. You should install the Wireless LAN Card (SWL-2210M/P).
3. Install the software using the Installation CD.
4. Install the network protocol(s) required to communicate on your network. Most
likely you will need the TCP/IP protocol.
3.2 Installation Procedure of Windows 98
Please follow the following steps one by one to install the MiniPCI/PCI card successfully.
< Method 1 - Inserting card first >
1. Insert the MiniPCI/PCI Card into the slot of your computer.
2. Power on your computer and allow
Windows 98
to load fully.
3. “
Add New Hardware Wizard
” appeared and the system looks for “PCI
Network Controller”. Press ‘NEXT’ button and check if “Search for the best
driver for your device(recommended)” is slected and then press ‘NEXT’
button . Insert the MagicLAN Installation CD into the CD-ROM drive.
4. Mark the “Specify a location” tap and type “
E:\Drivers
” right below in this
tap(Where E is the CD-drive of your PC) and then press ‘NEXT’.