Filter
Top Products
User’s Manual 36
On-Screen Display
Use this menu to choose between the signal source connected to the BNC
connector input and the signal source connected to the D-SUB connector input.
Note: When you are finished, wait for a few seconds and the screen will blank
then display the image from the new signal source(other computer).
A cable must be connected to both inputs to use this function.
1 Push the Menu ( ) button.
2 Push the
button or button until the Advanced screen is displayed.
Push the
button or button to select D-SUB/BNC.
3 Push the Menu ( ) button to open the D-SUB/BNC selection screen.
4 Use the
button or button to select D-SUB or BNC.
You can see the frequency (user control mode) used by the user, the polarity of
the operational signals, the default frequency (default mode) set when you buy
the monitor and the resolution level.
Note: These screens do not allow any changes to the settings, they are for
information only.
1 Push the Menu ( ) button.
2 Push the
button or button until the Menu screen is displayed.
3 Push the Menu ( ) button to open the Display Timing
adjustment screen.
4 Use the
button to see the user control mode and the default mode.
Menu
How to adjust
D-SUB/BNC(Option)
Display timing