Sanyo PLV-Z700 Projector User Manual


  Open as PDF
of 60
 
19
Press the POWER ON/STAND-BY button on the top control
or on the remote control. “Power off?” appears on the
screen. Press the POWER ON/STAND-BY button again to
turn off the projector.
When the Power off confirmation function is set to “Off,”
the projector can be turned off without the confirmation
message. (See “Power off confirmation” on page 40.)
The automatic slide shutter closes and the POWER indicator
starts to blink red. The blinking continues for about 90
seconds while the cooling fans are running.
1
TO MAINTAIN LIFE OF LAMP, ONCE YOU TURN PROJECTOR
ON, WAIT AT LEAST FIVE (5) MINUTES BEFORE TURNING IT
OFF.
DO NOT PRESS THE MAIN ON/OFF SWITCH TO OFF AND
UNPLUG AC POWER CORD WHILE COOLING FANS ARE
RUNNING OR BEFORE POWER INDICATOR STOPS BLINKING.
OTHERWISE IT WILL RESULT IN SHORTENING LAMP LIFE.
2
When the projector is cooled down enough to be turned on
again, the POWER indicator stops blinking. Then you can turn
the Main On/Off switch off and unplug the AC power cord.
“Power off?” disappears after 4 seconds.
Turning Off the Projector
✔Note:
•Iftheautomaticslideshutterisclosedduringoperation,the
projectorisautomaticallyturnedoffforsafety.Besuretoturnoff
theprojectorbypressingthePOWERON/STAND-BYbuttononthe
topcontrolorontheremotecontrolafteruse.
•WhilethePOWERindicatorisblinking,thelampisbeingcooled
downandtheprojectorcannotbeturnedon.WaituntilthePOWER
indicatorstopsblinkingtobeturnedonagain.
•Therunningspeedofcoolingfansischangedaccordingtothe
temperatureinsidetheprojector.
•IftheWARNINGindicatorblinksoremitsredlight,see“Warning
Indicator”onpage44.
•Donotputtheprojectorinacasebeforeitiscooledenough.
Basic Operation
DO NOT OPERATE THE PROJECTOR CONTINUOUSLY
WITHOUT REST. CONTINUOUS USE MAY RESULT
IN SHORTENING THE LAMP LIFE. TURN OFF THE
PROJECTOR AND LET STAND FOR ABOUT AN HOUR IN
EVERY 24 HOURS.
 previous next