Filter
Top Products
46
Turn the projector on and press the MENU button to display
the On-Screen Menu. Select the Setting Menu with the Point
ed buttons. Press the Point 8 or OK buttons to access the
submenu items.
1
Put the blower’s nozzle into a hole.
2
Blow air into the projector with the blower watching the
position of the dust from the screen.
3
Set the projector back into the right position, then press any
button on the top control or on the remote control to quit the
Cleaning function.
4
5
Clean by using the Cleaning function in the Setting Menu
Select Cleaning and then press the Point 8 or OK buttons.
The screen is blacked out temporarily.
Turn the projector over. Put your finger on the hole cover’s
tab and pull to open the hole cover.
When cleaning is done, pull the blower out of the hole and
replace the hole cover.
6
7
Put your finger on
the hole cover’s tab
and pull.
The nozzle will go no
further than a certain
point when it is put
into the hole. Do not
attempt to push the
nozzle further in, or
it could break and be
stuck inside of the
projector.
* Do not open the hole cover except when you clean the inside of the projector to
prevent foreign matters from getting into the projector. If it is open especially while
operating the projector, the optical parts could damage.
Which hole to put the nozzle in?
When you look at the screen:
● When red spots (dust) are particularly noticeable, put the
nozzle into the R panel cleaning holes.
● When green spots (dust) are particularly noticeable, put
the nozzle into the G panel cleaning holes.
● When blue spots (dust) are particularly noticeable, put the
nozzle into the B panel cleaning holes.
Wave the nozzle back and forth inside of the
projector.
(Do not attempt to bend the nozzle.)
Use only the supplied blower and nozzle.
Do not use a commercially available
compressed air duster. It causes the
interior of the projector to malfunction
with release of cold liquid propellant. We
could not guarantee the malfunction of
breakage by using other tools.
Cleaning
Select Cleaning in the
Setting Menu.
Maintenance and Cleaning
Tab
Hole cover