Sanyo PLV-Z700 Projector User Manual


  Open as PDF
of 60
 
29
Press the Point 7 button to decrease the sharpness of the image;
press the Point
8 button to increase the sharpness of the image
(from -7 to +7).
Sharpness
Lamp control
Use the Point 7 8 buttons to adjust the gamma value to obtain a
better balance of contrast (from -7 to +7).
Gamma
An interlaced video signal can be displayed in progressive. Use the
Point
7 8 buttons to select the desired options.
Off . . . . . Disabled.
Video . . . For moving pictures.
Auto . . . . Auto adjustment according to the video signal or film
signal (3-2 and 2-2 pulldown video sources.)
Progressive
This function allows you to change the brightness of the screen.
Use the Point
7 8 buttons to select the desired lamp mode. You
can also select the lamp mode by pressing the LAMP CONTROL
button on the remote control.
Normal. . . . . Normal brightness.
Auto 1 . . . . . The brightness according to the input signal.
Auto 2 . . . . . Less bright and lower-sound than Auto 1.
Eco. . . . . . . . Lower brightness reduces the lamp power
consumption.
The lamp mode is automatically switched to “Eco” under no signal
input.
Noise reduction
Press the Point 7 button to lighten red tone; press the Point 8
button to deepen red tone (from -31 to +31).
White balance (Red)
Press the Point 7 button to lighten green tone; press the Point 8
button to deepen green tone (from -31 to +31).
White balance (Green)
Press the Point 7 button to lighten blue tone; press the Point 8
button to deepen blue tone (from -31 to +31).
White balance (Blue)
✔Note:
•IfanyoneoftheWhitebalance(Red,Green,orBlue)areadjusted,
theColortemp.levelchangesto“User.”
•Progressivecannotbeselectedwiththecomputerinputandwhen
thevideosignalformatis480p,575p,720p,or1080p.
•Noisereductioncannotbeselectedwiththecomputerinputand
whenthevideosignalformatis1080p.
Press the Point 8 or OK
buttons to display the
Advanced menu.
Go on to the next page....
Image Adjustment
Noise interference on the screen can be reduced. Press the Point
7 8 buttons to change the noise reduction mode.
Off . . . . Noise reduction mode is “Off”
On . . . . Noise reduction mode is “On”
Use the Point 7 8 buttons
to adjust the setting
values and press the OK
button.
If you press the Point
d
button, the next item can
be selected.
The selected item.
Press the Point 8 or OK
buttons to access the
selected item. The adjust-
ment bar is displayed.
 previous next