Filter
Top Products
14
Chapter 2 Installation
x Installation and Network configuration
Mounting
1 Turn the Mains switch off.
2 Remove 2 screws on a board
from any of the slots 1 to 4, and
then pull the board out from the
projector.
3 Put the Board into the board slot
along the guide. Mount the
board connector into the socket
in the slot firmly.
4 Secure the board with two screws
(supplied).
✐ Mains switch must be turned off when mounting or removing this product otherwise it may
damage the product.
✐ Do not install multiple network boards into a projector otherwise it may damage the product.
✐ Do not connect the AC cord until after connecting the LAN cable and computer.
Caution
!
WARNING
TEMP.
READY
LAMP
REPLACE
LAMP
Guide
Mains Switch