Filter
Top Products
32
Chapter 3 Basic Setting and Operation
● When the internal power circuit is failed:
● When the life span of lamp is reached:
✐ Replace it with a new lamp immediately and reset the lamp counter. If the projector
is used without reset the lamp counter, the alert mail is sent to users in every power-
on of the projector. This alert mail will not be sent when unchecking the mail sending
condition "When the life span of lamp is reached".
TITLE: Message from projector
07-10-2003 00:59
Projector Model Name: PLV-HD10
TCP/IP: 192.168.1.201 Projector Name: myProjector
It sends you following message.
*The Projector lamp was turned off, because projector power circuit failed.
Unplug the projector from AC outlet and ask servicing to qualified service
personnel.
Information: FFFEFFFF
TITLE: Message from projector
07-10-2003 00:59
Projector Model Name: PLV-HD10
TCP/IP: 192.168.1.201 Projector Name: myProjector
It sends you following message.
*The life span of lamp is reached.
✐ The Projector lamp was turned off, because the projector power circuit failed.
Unplug the projector from AC outlet and ask servicing to a qualified service personnel
with the information code “FFFEFFFF”.
● When the lamp use time reaches preselect lamp use time:
✐ The Network Board sends a free message when the lamp use time reaches the pre-
selected lamp use time. It can be used for preparation of the lamp replacement and
the maintenance required.
TITLE: Message from projector
07-10-2003 00:59
Projector Model Name: PLV-HD10
TCP/IP: 192.168.1.201 Projector Name: myProjector
It sends you following message.
*The lamp use time reaches 800 hours. Prepare the lamp replacement.
Free messages