31
Network Board
OWNER’S MANUAL [HD Series]
ENGLISH
4 Condition selection for sending
alert message
Check the condition items under
which alert messages will be sent and
click Set button.
A free message can be sent when the
lamp use time reaches the preselect-
ed lamp use time.
Check this condition and enter a set-
ting time. Type a free message on
“Attached Message” text box and the
click Set button.
* The length of message should be less
than 256 characters.
* The lamp use time can be set 0 to 9999
hours.
Examples: Type and contents of alert mail
When the projector has an abnormality, the following alert messages are sent to the
registered E-mail address according to your selected condition. Administrator or user
can take an efficient action quickly by receiving this message. This is very useful to
maintain and service the projector.
The following are examples of received messages.
● When the internal temperature is too high:
✐ The Network Board let users know the information which thermal sensor [A] or [B] inside
the projector detected the abnormal temperature risen and so the projector was turned
off. Please refer to item “Check the status of projector” for the location of the sensors [A]
and [B], and temperature (☞ p.35). Also see the owner's manual of the projector for fur-
ther details.
TITLE: Message from projector
07-10-2003 00:59
Projector Model Name: PLV-HD10
TCP/IP: 192.168.1.201 Projector Name: myProjector
It sends you following message.
*The Projector lamp is turned off, because internal projector temperature is too
high.
Wait Temperature Warning Indicator turned off,turn the Projector on again.
If the Indicator continues to flash,check the air filter for dust accumulation.
[A] 36.5 Degree [B] 58.2 degree
Temperature of Sensor B is too high.
E-mail Setting
x